Issue by : Can allure trafficmaster resilient plank flooring on a subfloor that is not amount?
The subfloor is manufactured of 3 inch extensive flooring boards, and the joists below them just isn’t stage. The region where the worst part of the subfloor is in a line that has about a ten degree (tough estimate) drop. Soon after that, it is pretty degree. I could have a new plywood subfloor put about the flooring boards for a few hundred bucks, but I’d favor to just put the allure planks over the previous subfloor. It really is in a rental residence and it does not have to be amount, but then once again I will not want to have the planks crack. If I do set the planks about the aged flooring, must I place the planks perpendicular to the line that has the 10 degree drop, or must I place them in the identical direction?

Thank you!

Very best remedy:

Reply by Karen L
I don’t feel the lack of level will be a problem as extended as it’s a gradual dropping off. They are vinyl and they are relatively adaptable. I think I’d place them perpendicular to the line along which the floor drops. But the three inch boards may well be a issue. If the boards have any gaps or unevenness or knots, and boards normally do, then the vinyl will have a tendency to mildew by itself to these gaps and uneven elements and these faults will show via, ultimately. I place my Allure flooring over yet another vinyl floor and I employed a compound to fill in the little textured routine on the previous vinyl flooring so the texture would not transfer to the new floor. All vinyl flooring demands to go on a truly smooth surface area to appear its best. I took intense care when I laid the vinyl planks, vacuuming every single area prior to a row of planks went down, but I should have missed a couple of spots and some minor piece of grime acquired below the planks. Could not see it even though I was laying them but the tiny bump showed up a handful of weeks later. I believe if you do not put some smooth underlayment down, you’ll regret it later. Even that extremely thin plywood referred to as luan would be far better than the boards.

Know far better? Leave your own reply in the remarks!